tools required
32mm socket (for the big bronze axle nut)
17mm socket ( for the ball joint castle nut and the bolt between the lower control arm and the shock mount)
pliers (to remove cotter pin from balljoint)
17mm wrench (to hold one end of the bolt explained previously)
10mm socket (to move a brake line so it doesnt get in the way)
pry bar/ large flat head screw driver (to pop axle out of trans)
19mm socket to remove lugnuts(provided they are stock)
ball joint seperator and big hammer, can be done with just a big hammer if hit right
that is everything you need to do the project, if you dont have it all i would take it some where
Home 
