What caim has been up to.

Well at work (fighters) we have been working on a tt 350z. The customer wanted the tt kit taken off because he wants to sell it and trade in the car. Had to pull the motor to do so, so it was quite a bit of work. Here are a few pics of the job. What i could get off of the phone at least. Def a learning experience a i know more about that car then i ever did before. Taking those turbos off makes taking off the headers seem like a walk in the park now ha.





















started on the fuel pump on it today and have to wait for him to get the rest of the parts to me and then i can finish that. This is the aps fuel pump



Was working on getting this sr in the 240 the guy dropped off. Check this out......



Pulled the tranny off cause he wanted a better clutch, and this is what the old one looked like.





Also today mounted some drag tires for my friend tj. These wheels were super light and sweet at that. They weighed six and a half pounds.








Rolled some fenders on a camero






Got joshes evo in for a clutch



And finally did an exhaust on a new charger and it had the worlds longest exhaust peice



Man that thing sucked hahahaha

but yea, good times at work for sure.

Pics of that Clutch assembly ... Katrina ??

Hahaha, yeah that thing was rusty as fuck!

Damn, as far as intake manifolds go, that's the coolest looking one I've ever seen.

It's obvious you guys enjoy your work and it's impressive to see how much you get accomplished in a day! Keep up the great work!

^ thanks man, and yea we have been busy.

That clutch was so wack and that is what cause the drifting in the vid to be not so good. So i worked on that today hahaha. Runs a lot better.

But here are some things that i did today.

Worked on the 350 just putting a few things on it that the customer brought in.

After that took that sweet clutch out of the sr and replaced it with this.





Same guy that is paying us to do the swap also got a front mount so i started to put that in today. Got to the point where i have to start cutting the bumper before i ran out of nice weather.





While i was unboxing that, dale finished building a fd motor. This is in the middle of it though.




On the sr, i had to cut the front bumper support to fit the ic and also cut wholes in the panels to fit the ic pipes that are not normally there.










Also mounted some wheels and tires, but they were to cool to take pics of today...... Busy day so it was all good. Tomorrow is saposed to be busier. Good timez.

great work man keeping busy

Lot of great work Caim, keep it up

awesome work man